- High-quality Polyester Material - The Pellon PLF36 Fusible Interfacing is made from high-quality 100% Polyester that works for any light and medium-weight fabrics. It’s ideal for use in various types of light fabrics such as linen, broadcloth, chambray, challis, and jersey. It also works well for delicate fabrics.
- Size is perfect for medium to large projects - Every Pellon PLF36 Sew-In Interfacing package is 15” x 3 yards, making it perfect for medium to large projects. It’s also convenient to use on several small-size garments by simply trimming the interfacing to any pattern based on your requirements.
- Thin and lightweight - The Pellon PLF36 Fusible Interfacing is lightweight and thin that you would barely notice its presence on the fabric. It sticks to the material through an adhesive that can be activated with pressure or a damp cloth.
- Strengthens fabric stitching - This product is also perfect for protecting and strengthening fabric stitching, as well as providing structure for collars and facings.
- Easy to clean - It’s easy to clean and can either be machine washed or dry cleaned with your fabrics.
Pellon PLF36 Fusible Interfacing is an ultra lightweight interfacing for light to medium-weight fabrics. It is great for woven, knits, blouses, and sheer garments. It is excellent for use with crepe de chine, voile, and handkerchief linen fabrics. It can also be used for stabilization of quilting projects. 100% Polyester Lightweight fusible interfacing Machine wash warm. Tumble dry low or dry clean. General Directions: 1. Pin pattern piece to interfacing following grain-line arrows and cut. 2. Trim seam allowances to 1/4″. 3. Place fusible side of Pellon against wrong side of fabric. 4. Pin, then steam-baste along edges with tip of iron. Remove pins. 5. Set iron on Low-Permanent Press setting. (Use steam iron with metal sole plate. Hand-held steamers will not permanently bond interfacing to fabric.) 6. Cover with a damp press cloth and press down firmly for 10 seconds. 7. Repeat, lifting and slightly overlapping iron until all interfacing is fused. 8. Steam press on right side. 9. Let fabric cool, then check bond. There is no pre-shrinking required. Always pre-test with a swatch of fabric to make sure it is compatible with the fusible. Fusing is not recommended for triacetate, lace, seersucker, or rainwear. Use your damp press cloth as a temperature and timing guide. After 10-15 seconds, press cloth should be dry. If not, raise iron temperature or hold iron in place a few seconds longer.
